About Bradford Attic Insulation
Attic Insulation For The Homes Bradford Built
Bradford Attic Insulation insulates attics in Bradford, Bond Head, Schomberg and along the Holland Marsh, and most of the houses we work on never got past builder-grade levels. Every attic job carries full insurance. We measure the attic, seal the ceiling, build the layer up to R-60 and write down where it finished.
About Bradford Attic Insulation
Why We Focus On Newer Attics
Bradford has grown faster than almost any town around it, and the houses on its newer streets tend to share one attic story. The builder put in the minimum, the fill sank, and the edge over the outside walls stayed thin.
We climb into that attic every week, so we know where to look and how long the work takes. It keeps our quotes short and easy to follow. Older homes in Schomberg and around Kettleby get the same attention, with a closer look at the attic insulation already up there.
A Free Depth Reading Before Any Price
Every price we give follows a visit. Someone from our team climbs into the attic, reads the depth across the floor, checks each vent and fan duct, and takes photos. You see the same photos and readings we do, so the quote makes sense.
The Order Of Work Never Changes
Sealing comes first, then baffles at the eaves, then the hatch, and only after all that the new attic insulation. That order is what lets the new layer perform, and every job we book follows it, even a small top-up.
Depth Is Marked, Measured And Written Down
Rulers are fixed to the trusses before the hose comes up, so everyone can see the target. Once the floor is done, we read the depth again and put the R-value it reached on the invoice. Those numbers stay with the house.
Clean Work Inside Your Home
Drop sheets cover the path to the hatch before anything starts. Fill is pumped up a hose from the truck parked outside, which keeps bags and debris out of your living space. We vacuum the hallway and close the hatch on our way out.
Talk To Us About Your Attic
Call (289) 210-8362 or use the request box to book a free depth reading, or read about each service from the Bradford attic insulation home page. You can also find every way to reach us on the contact page.
Attic Work We Take On
Each one begins with a free depth reading and ends with the finished R-value on your invoice.
-
Blown-In Attic Insulation
Blown-in attic insulation spreads one unbroken layer across the attic floor, eave to eave, and reaches R-60 at the right depth. It suits empty attics, patchy batts and any floor with open joist bays.
-
Attic Insulation Top-Up
With an attic insulation top-up, fresh fill is blown on top of the layer you already have until a thin or sunken attic floor reaches R-60. Dry, clean material underneath is left right where it lies.
-
New Home Attic Insulation Upgrade
A new home attic insulation upgrade takes the minimum layer a builder left and builds it up to R-60, fixing the eaves, the hatch and the ceiling holes as it goes. For most newer Bradford houses it is the first upgrade worth doing.
-
Attic Air Sealing
Attic air sealing shuts the holes in your ceiling where heated air slips into the attic, from recessed lights and fan boxes to the hatch. It is step one on every insulation job we take.
-
Attic Ventilation
Good attic ventilation draws cold, dry air through the soffits and releases it up near the ridge, which keeps the roof deck dry through the winter. We look at attic ventilation in every attic, because new insulation must never block it.
-
Attic Insulation Removal
Attic insulation removal vacuums out damp, mouldy, flattened or rodent-fouled insulation, leaving a bare floor ready for sealing and fresh insulation. Attic insulation removal is the right first step when the old layer can no longer do its job.
-
Attic Insulation Rebate
Ontario's attic insulation rebate covers part of the cost of raising an attic to R-50 under Home Renovation Savings, a program Enbridge Gas runs jointly with Save on Energy. Below is what it pays, who can apply and how contractors fit in, last checked October 2026.
-
Attic Insulation Cost
Attic insulation cost in Bradford mostly falls between $1.20 and $3.00 per square foot, which is about $1,200 to $3,000 for an average subdivision attic. Your exact figure arrives on paper once a free depth reading is done.
Ask For Your Free Depth Reading
Give us the basics on your home, and our office will phone back to pick a visit date. Calls go to +1 (289) 210-8362.